Sale!
,

USB Host Shield for Arduino


Compare

• Use your Arduino boards to control USB devices
• Write code to interact with the host shield and your Arduino system
• A MAX3421E USB Host Controller with SPI Interface is the heart of this board
• Complies with USB Specification Revision 2.0 (Full-Speed 12Mbps Peripheral, Full-/Low-Speed12Mbps/1.5Mbps Host)

£24.99 £26.99

Product details

USB Host Shield for Arduino

• Use your Arduino boards to control USB devices
• Write code to interact with the host shield and your Arduino system
• A MAX3421E USB Host Controller with SPI Interface is the heart of this board
• Complies with USB Specification Revision 2.0 (Full-Speed 12Mbps Peripheral, Full-/Low-Speed12Mbps/1.5Mbps Host)
Click Here for the USB Host Library
To visit the website support page please click here

The USB Host Shield contains all of the digital logic and analogue circuitry necessary to implement a full-speed USB peripheral/host controller with your Arduino. This means you could use your Arduino to interface with and control any USB slave device – thumb drives, digital cameras, Bluetooth dongles, and much more!

A four-wire serial interface is used to communicate with the host controller chip, so the shield connects the Arduino’s hardware SPI pins (D10-13) to the MAX3421E. A USB type female connector is wired up to the IC, and it also supplies 5V as any normal USB port would.

The Host Shield takes its power from the ‘Vin’ pin on your Arduino. Power from that pin is regulated to both 5V and 3.3V on the shield. All SPI signals are sent through a hex converter to step them down to 3.3V.

• Max Current: 60mA
• Dimension: 60.0×53.5×19.5mm
• Net Weight: 16g

Categories: ,

Based on 0 reviews

0.0 overall
0
0
0
0
0

Be the first to review “USB Host Shield for Arduino”

There are no reviews yet.